Start with what the question asks for
In a single-phase AC circuit, apparent power S equals RMS voltage multiplied by RMS current, S = V × I. Its unit is the volt-ampere, or VA. Real power P is the average rate at which energy is transferred to the load and converted to heat, mechanical output or other forms. Its unit is the watt. The same circuit can have a reading in VA and a different reading in watts.
For sinusoidal AC, use RMS voltage and current in these equations. If the question explicitly gives a peak value for a sine wave, divide by √2 to obtain the RMS value. A 170 V peak sine wave is approximately 120 V RMS. Write “RMS” next to converted values so you can see at a glance which numbers belong in the power calculation.
Put power factor on the right side of the equation
Power factor is the ratio P ÷ S when apparent power is greater than zero. If a question gives a power factor of 80%, write 0.80. To find real power from voltage and current, multiply by power factor, P = V × I × PF. To find current from real power, divide by the product of voltage and power factor, I = P ÷ (V × PF). This second equation assumes PF is greater than zero.
For sinusoidal voltage and current, power factor equals cos φ, where φ is the phase angle between them. In a purely resistive load, the waveforms are in phase and PF equals 1. An inductive load can draw current that lags the voltage. With a lower power factor, a load delivering the same real power at the same voltage draws more current. That relationship is a quick check when an answer seems backward.
Use the units to choose your first step
If the prompt gives volt-amperes and asks for amperes, divide VA by volts. If it gives watts, convert to VA using the power factor, then divide by volts. You can write the two steps as one equation after you are comfortable with the distinction. Convert kW to W or kVA to VA before working with whole volts and amperes.
Watch for a motor question that supplies shaft output power alongside efficiency. Shaft output is mechanical power. Divide by efficiency, expressed as a decimal, to obtain real electrical input watts. Then use power factor to relate those input watts to input VA. Keeping those two ratios separate makes every intermediate quantity easier to label and check.
To practice the unity-power-factor case, try a 12 Ω ideal resistor at 24 V RMS in the Ohm’s law calculator. It gives 2 A and 48 W. The apparent power is also 48 VA because the waveforms are in phase. The same voltage and current at a power factor of 0.75 would give 36 W in a load with that power factor.
Try a question
A single-phase load draws 960 W of real electrical input power at 120 V RMS and a power factor of 0.80. Find the apparent power and RMS current.
Show the answer
1,200 VA and 10 A RMS.
Divide 960 W by 0.80 to get 1,200 VA, then divide 1,200 VA by 120 V to get 10 A. Check by multiplying 120 × 10 × 0.80 to recover 960 W. At unity power factor the same watts would take 8 A, so the 10 A result moves in the expected direction.